I can't copy a circuit using the instructions from a booklet.

Question

I have just started using Unidraf5 yesterday. I was handed a booklet that I have been going through, called "The Primer Of Unidraft" and I am on page 10 and 11 where it talks about copying a small circuit that I have placed. I can't seem to copy the circuit at all. I have tried it over and over and it just don't seem to work. There was one time I thought it was going to work when the circuit changed to red, but that didn't work either. What can I do?

Answer 1

Firstly, I recommend you check if the booklet you have is for Unidraf5 software developed by a Japanese company called SINWA. Also, make sure that it refers to your version of the application. The version of the program should be displayed in the first or second page. Also, you can check the version of your software if you go to Help > About. If the booklet is for your software, try uninstalling and then installing the program again. If this doesn't help, use [email protected] email address to get in touch with the support team.