The software detects the network signals but when you press the connect button, it says "Connecting" and stays there. What could be the problem?

0 votes
No avatar asked by (120 points) about BAM HUAWEI
edited by

The software detects the network signals but when you press the connect button, it says "Connecting" and stays there. What could be the problem?

1 Answer

0 votes
answered by (264k points)
edited by

Check the drivers of the device in Device Manager. Make sure that the device is installed properly. If you are in Device Manager, make sure that there are no network adapters disabled and everything is working fine. This could also be a configuration-related issue and you should re-install the application in that case. Signal might cause this problem as well, if you're using a USB modem. The device can't acquire the signal to make the connection.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...