First time here? Check out the FAQ!
x

Icon bar disappears after cutting or engraving in CorelLASER 2013.02.

0 votes
asked by about LaserDRW
edited by

Is there a fix or upgrade for the icon bar which disappears after cutting or engraving in CorelLASER 2013.02 following a Windows 10 upgrade. All was good while using Windows 8.

1 Answer

0 votes
answered by (236k points)

Just like you mentioned, this is a problem related to compatibility between your application and Windows 10 operating system. There are still apps available on the Internet that haven't been properly updated to support Windows 10. You can apply a compatibility tweak to the main executable. Right click it, go to Properties > Compatibility and select Windows 8/Windows 8.1 from the list. Tick the Run as Administrator as well and then launch the application.

I have also checked and this is the only version of the software. The official website lists exactly the version you have on your PC.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...