First time here? Check out the FAQ!
x

Nothing to render on the screen.

0 votes
asked by about energyXT
edited by

We are using 2.6 to record Church Service. We are recording on the same computer being used to run the Projection System for Church. Many times lately when we Export to WAV, we get "Nothing to Render". I have gone back through the files saved & sometimes there is a good recording & other weeks a small file with nothing in it. When I test for a minute or so, I always get a good file. Does the program just 'stop & dump' after running 'too long'? Sometimes we record an hour & sometimes 1 1/2 hours (recording just 1 track).

1 Answer

0 votes
answered by (309k points)

This error could be caused by the codecs the program is using or because it's outdated. In either case, install a new set of codecs through the application's page at Software Informer. After you've installed the codecs, restart the software and then try to export again. Additionally, configure the settings for the exported files to something else.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...