Measuring problems in MCOSMOS V3.4 and CAT1000.

Question

I'm using MCOSMOS V3.4 and CAT1000 to measure automotive sheet metal stamping parts. Material thickness is 1-2mm. Since wall position is changing too much, more than 1mm in some parts, the programming points to measure its trim edge may not always be touched properly by running programs. What should I do to make sure that my points for trim edge will be touched properly?

Answer 1

Unfortunately, there is no information about what you will need to do to make sure that your points for trim edge will be touched properly. My recommendation is to contact the official developers of the software and ask for instructions. You can get in touch with them using the Contacting MAC page.