Cutter compensation

Question

Why G41 cutter compensation does not work on cut Viewer mill? I can leave in the G41 or out the result is the same.
%17
(STOCK/BLOCK,140,120,10,0,0,10)

(COLOR,255,0,0)
(TOOL/MILL,10,0,100,0)
(COLOR,0,255,128)
N10 T1
N20 G00 X-20 Y-50 Z2 S+1200
N30 G01 Z-12 F100
N40 G41 X0 Y50 G01
N50 G01 X50 Y50
N60 G03 X70 Y70 I0 J20
N70 G01 X70 Y100
N80 G01 X120 Y100
N85 G01 X120 Y20
N90 G02 X100 Y0 I-20 J0
N110 G01 X20 Y0
N105 G02 X0 Y20 I0 J20
N120 G01 X0 Y50
N440 M30

Answer 1

It is possible that the G41 cutter compensation feature may not be supported in CutViewer Mill. You may want to consider reaching out to the software provider for more information or check if there are any updates or plugins available that can enable this feature.