Windows Mac Forum
Ask a Question

Why it stops during cutting and after reset it won't finish cut while using GRBL 3.6.1?

0 votes
asked by about Grbl Controller
edited by

I'm using Aspire 8.0 for my designs, if this will help resolve my problem.

2 Answers

0 votes
No avatar answered by (236k points)

You need to open a post with this problem on the GitHub project page in the Issues section. An account is necessary though.

Access the following link to reach the Issues section directly.

I am recommending this because of the lack of support for Grbl Controller.

0 votes
answered by (260 points)

agree with the opinion of Robert Polubinski

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
Copyright © 2024, Informer Technologies, Inc.
...