First time here? Check out the FAQ!
x

Change scale in measurement.

0 votes
asked by about ATPDraw
edited by

Hi,

I am trying to simulate power system fault using ATPdraw, measuring currents/voltages before sending it to Omicron to generate a smaller scale of the same profiles. All my measured voltages and current are in kV and kA. I know I need to scale it down before sending to Omicron. Is there a way to do so?

Thanks!

1 Answer

0 votes
answered by (329k points)

Since I didn't find anything available your issue, I recommend registering for an account to read the documentation available on the official website.

Note: You also have to answer to the EMTP quiz before the system can accept you. If you have a previous version of the software, then I recommend upgrading to the latest one as well since the downloads are available only to registered users.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...