Burning AT89c51 with SP200s.

0 votes
asked by about Willar Programmer
edited by

I'm trying to burn at89c51 with sp200s. "Device ID Error" is given.

1 Answer

0 votes
No avatar answered by (309k points)

You need to have the correct drivers and the correct port set in the application. With all the devices attached and the software started, go to Start > Run > devmgmt.msc. Expand Ports and LPT then right click on Silicon Labs. Switch to Port Settings tab and click on Advanced. Choose COM2 or COM12 and then reconnect again and everything should work properly.

0 votes
answered by

showing communication error in willar programmer

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...