First time here? Check out the FAQ!

Servo motor control using macro.

0 votes
asked by about Flowcode V5 - free version
edited by

I want to control the position of a servo motor using Flowcode (macros). When I simulate on ISIS it is not rotating to the desired angle. The motor goes to +90 or -90 degrees and stops. I think the problem is in the frequency setting. Can anyone help?

1 Answer

0 votes
answered by (329k points)

The Flowcode developers have created a WiKi page where you can see how to create a macro for the servo controller. This allows you to control various functions of the servo motor. It doesn't matter if the version linked is for Flowcode V6, because it will work for version 5 as well. Access the page below to learn more about this.

Wiki page:

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register