Can't find port on FlexiSigns Pro 7.

0 votes
asked by about FlexiSIGN-PRO
edited by

I can't find the COM port I need on my production manager and in cut plot also of the Flexi Signs Pro 7. When I open my production manager and try to add the port it does not appear, but when I go to my Device Manager, my COM port does appear. What can I do to get my COM port to appear again on my production manager and on cut plot?

1 Answer

0 votes
No avatar answered by (193k points)

From what is seems, the ports are stuck or frozen. This happens even with the USB ports because of unknown causes or drivers. My advice is to access the Device Manager again and simply remove the COM devices from the list. Don't remove the driver, only the device. Close Device Manager and reboot the computer. After it boots, the driver should be installed again and the COM ports will be available in the application as well.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...