First time here? Check out the FAQ!

Mitutoyo Formtracepak V5.2 calibration information.

0 votes
asked by about Formtracepak
edited by

Batch Calibration fails on the small diameter pin when calibrating a flat blade probe, but it calibrates fine on the round point probe. I have already confirmed that the probe is square to calibration block. Is there something else I may be missing or a different way to calibrate flat probes?

1 Answer

0 votes
answered by (329k points)

According to the official information found in PDF files, this should be the correct calibration method, however, the software is enhanced to perform calibration automatically instead of using the manual method. On a side note, it's possible that you are missing an element during calibration. I would like to recommend take advantage of its automatic function. In case of failure, it will say what needs to be changed then repeat the step.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register