Can't start the program due to an error.

0 votes
asked by about Alstom Optical Sensor Control Panel
retagged by

I am receiving an error as follows : "Failed to connect. Check the cabling to the system and serial port baud rate". Why is this happening?

1 Answer

0 votes
No avatar answered by (79.9k points)

The error that you encounter suggests that your system in not properly configured and you can't run the application yet. To fix this behavior, it's advised to check again if you properly connected the device to your PC. Also, make sure to check if you didn't set up a low or high value for the baud rate. The optimal value can be find in the device's spreadsheet. I suggest that you access the Help menu from the main interface of the application. There, you will find any related information that you can use to set up the program.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...