First time here? Check out the FAQ!
x

How to overcome "IS360.exe entry point not found " error message.

0 votes
asked by about IObit Security 360
edited by

I receive the following error: "is360.exe - entry point not found. The procedure entry point attached to console could not be located in the dynamic link library kernel32.dll".

1 Answer

0 votes
answered by (329k points)

This means that you are trying to run the software on a non-supported version of Windows (usually XP Service Pack 2). Install Service Pack 3 or a Windows version higher than Windows XP, then reinstall the software and it should work normally.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...