How to do the PLC to PLC communication by using Telepace studio software?

Question

I need to know the PLC-to-PLC communication. I referred your Telepace Studio training manual (MSTR block). We are using two Scadapack's for this demo operation in telepace studio software. One is scadapack357 - In this, we created the sample program by using one coil and one input register via serial communication. (When the input registers, gets energized the coil response). Finally, we want to get the data from Scadapack 357 to Scadapack 32. We need sample PLC programs of both the end and its configuration settings.

Answer 1

Regarding the question, to achieve PLC-to-PLC communication using TelePACE Studio software, you can follow the steps outlined in the TelePACE Studio training manual (MSTR block). Additionally, for the specific scenario you mentioned (Scadapack357 to Scadapack32), you will need to create sample PLC programs for both ends and configure the necessary settings for communication. Unfortunately, without further details about the specific requirements and configuration, it is difficult to provide a specific answer.