First time here? Check out the FAQ!
x

How do I move my stage from limit switch?

0 votes
asked by about PIMikroMove
edited by

Hi, I am trying to move one of my stages (a PI-M-531) to the Reference switch as I have done numerous times before, but it says that it is on limit switch and the following error pops up when I try to move it to Reference switch:

Error while referencing
Controller reported error 216
The Controller stage has driven into a limit switch, some Controllers need CLR to resume operation

How do I resume operation on my Controller?

2 Answers

0 votes
answered by (28.9k points)

There is a section at developer's website where you can address you question to the corresponding specialist.

0 votes
answered by (180 points)
reshown by

Roland - the specialist at pi-usa.us is not replying to my questions. How long should I wait?

commented by (28.9k points)
Try giving them a call:

East: 508-832-3456
West: 949-679-9191
San Francisco Area: 408-533-0973

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...