First time here? Check out the FAQ!
x

About pump features.

0 votes
asked by about Bentley WaterGEMS V8 XM
edited by

I am a fairly new user to WaterGEMS. In one of the model EPS runs, it shows that one of the pumps exceeds the max. operating point specified for the pump curve. Can I carry on with my analysis ignoring this message? How do I change pump settings to avoid it?
Thanks.

1 Answer

0 votes
answered by (309k points)

The Bentley developers have acknowledged on their website that this is actually an issue with the software and there is already a solution viable and explained on their Communities website.

I recommend you read everything on the following link to see exactly how to proceed with this problem: http://communities.bentley.com/products/hydraulics___hydrology/w/hydraulics_and_hydrology__wiki/24830.pumps-are-operating-at-a-much-higher-rate-than-the-design-point-pump-exceeds-the-maximum-operating-point-specified-for-the-pump-curve

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...