First time here? Check out the FAQ!

Shock pulse measurement.

0 votes
asked by about OMNITREND
edited by

I have the bearings listed in the frequency markers tab of the machine, and I wish to add a shock pulse measurement on the horizontal planes of each bearing. The wizard is requesting a diameter of the bearing, which I do not have, and should not need as the bearing is already entered in the frequency marker. Not sure what I am missing? And should the bearings be listed at the machine train level?

1 Answer

0 votes
answered by (236k points)

I have searched the web, but no one encountered the same issues as you currently experience. On the official website, there are manuals and documents you can use to overcome the issue.

Use the following page to download the Getting Started guide:

There are other documents as well. Consult them to see how to configure the application and its environment.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register