Error: (H32713) Value below allowable minimum.

0 votes
asked by about Autohydro
edited by

I have imported an Oil tanker in Autohydro. Then I input a max-vcg code as following code:
clear report

LIMIT TI International Code on Intact stability code, 2008

LIMIT AREA:RAD
Limit(1)  AREA from  0 to  30 >   0.0550       
Limit(2)  AREA from  0 to  40 or FLD >   0.0900       
Limit(3)  AREA from  30 to  40 or FLD >   0.0300       
Limit(4) RA at  30 >    0.200       
Limit(5) Abs Angle at Max >    25.00  
Limit(6) GM at Equil>    0.150 
limit ratio from roll to 50 or Fld> 1
limit(8) Absolute Angle at Equilibrium < 16
wind 53.4

trim0
calcmaxvcgdispl400,500,...,1200
trim1.43
calcmaxvcgdispl400,500,...,1200
trim0.99
calcmaxvcgdispl400,500,...,1200
trim0.53
calcmaxvcgdispl400,500,...,1200
trim-0.4
calcmaxvcgdispl400,500,...,1200
trim -0.88
calcmaxvcgdispl400,500,...,1200

I faced to a problem and in each step of trim software asked about original depth, trim and heel and in report with a message like title. I would be grateful if you can debug this matter.

1 Answer

0 votes
No avatar answered by (236k points)

This is an application that not many people know how to work with it or how to debug it. However, I can recommend another way. If you bought the application or are an active customer, use the following email to contact the developers: techsupport@autoship.com

As specified on the official website, email the project files as well and they should provide full support for application and the code you already have.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...