Latest questions about "engineering tools"

0 votes
1 answer 244 views
Where can I find the gird and radius, entry and exit options? What effect do they have on the safety factor?
asked May 5, 2011 by shreevarsha.br (120 points)
0 votes
1 answer 121 views
I would like to know how to do duct calculation?
asked Feb 11, 2011 by chander (120 points) about HVAC Duct
0 votes
1 answer 211 views
Using the NEPLAN 5.2.
asked Nov 29, 2010 by ace82 (120 points) about NEPLAN
0 votes
1 answer 414 views
I am making a design of a large building with many rooms. All the rooms have light fittings and all the calculations are set, but today I've needed to put in a new room and when I've pressed "Insert...
asked Feb 16, 2010 about DIALux
0 votes
1 answer 317 views
There are two software (Desigo Toolset and Desigo Xworks) for programming the same controllers. I was working in Xworks in India and now in UAE it is Toolset.
asked Jul 16, 2008 by rajan 2 (120 points) about DESIGO TOOLSET
0 votes
1 answer 408 views
How can I trigger an IGBT SCR thyristor? If I use a Pulse generator it displays the following error: "DC supply is not ground".
asked Jun 30, 2008 by nikunj 1 (120 points) about Proteus PCB design
0 votes
1 answer 235 views
How to use CKT1 CKT2 NT1 NT2 for condenser coil? Also, how to use the number of tubes for sub-cooling and where is the online Help service for this program?
asked Jun 8, 2008 by Shimi (120 points) about Lordan Calculation Program
0 votes
1 answer 276 views
I have a program to read the contents of holding register using ModBus RTU format. The problem is that it is not working with Screen Editor.
asked Jun 5, 2008 by shanishp (120 points) about Screen Editor
0 votes
1 answer 245 views
I am building a model using Revit MEP 2008 and I'm trying to use the direct link with IES VE for loading calculations. I found out that the loaded calculations are not very accurate.
asked May 28, 2008 by Mira Saad (120 points) about IES
...