Why when I load a g-code into Mach3 2.63 it does not show code on screen or run it?

0 votes
asked by about Mach3
edited by

Why when I load a g-code into Mach3 2.63 it does not show code on screen or run it?

1 Answer

0 votes
No avatar answered by (193k points)
edited by

For the code to display properly you will need to make sure that you're loading TAP file and then you can use Load G-Code button and it will display correctly. That will work if you're trying to add a DXF file to the Post Processor in SheetCam to generate the G-Code.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...