First time here? Check out the FAQ!
x

It doesn't remember the settings anymore.

0 votes
asked by (120 points) about PhotoPRINT SE Mutoh Edition
edited by

I've been using this program for two years and it has always remembered my settings. Recently I had to uninstall and reinstall it, and since then I have to set the configuration every time when I print something. What can I do to save the settings again?

1 Answer

0 votes
answered by (132k points)

After you set the desired settings, navigate to the installation folder of the PhotoPRINT SE software and run the Preference Manager utility which allows you to save all settings (all output device setups, setup properties, default job properties and so on) to a file. After you launch it, click Save, enter a file name and click OK. After that, every time you launch the program the settings will be loaded automatically. If not, just run Preference Manager, select the file and click Load.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...