First time here? Check out the FAQ!
x

How to update the EDID on GProbe board?

0 votes
asked by (120 points) about Genesis GProbe
edited by

I am trying to analyze DP data for a specific resolution/timing and for that need to updated the on board EDID. How do you do it? Is it possible to do it from Gprobe software?

1 Answer

0 votes
answered by (236k points)

Install the application then use the wizard setup to configure the EDID. At the end of the operation you will need to click on WriteEDID to finish it. Once you complete this, the EDID will be updated with the new one specified by you.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register
...